Nissan ECU Tuning

Beaver · Joined: 14 Feb 2008 Posts: 1

We have a problem with a zed not being able to shut down. Starts fine but when the ignition is turned to off, the engine continues to run. Conzult gave no errors in the ignition circuit The ecu to my way off thinking is working, as it should.
The t timer was disconnected, made no difference. The question is this. There is a black and yellow wire running from the ignition switch in the start position, to the ecu @ pin 43, is this wire an earth? Could someone shed some light as to what the B/Y wire dose?

Eric · Joined: 17 Nov 2003 Posts: 254 Location: Holland

In that case the ECU is most likely defective

swap it with a known good one to verify
_________________

DTA-motorsport

NewKleer · Joined: 09 Oct 2004 Posts: 159 Location: Sydney

have u got a wiring diagram? check an ignition switched source (maybe consult connector 12v? its only active when ign turn on) and see if it stays on when car switch off